This page summarizes common device configuration and maintenance tasks in LxCameraViewer. For installation, device connection, and the complete interface reference, see the LxCameraViewer user guide.
Before upgrading camera firmware or an application algorithm, confirm that the package matches the camera model. Do not disconnect power or the network during an upgrade.
Network and interfaces
Change the camera IP address
Open IP configuration tool from Other tools, select the target camera, and update its IP address, subnet mask, or gateway. Keep the host and camera on the same subnet.
Open Basic tools → Hardware interface and change the CAN baud rate or CAN ID. Devices on the same CAN bus must use the same baud rate.
Versions and upgrades
View software, firmware, and algorithm versions
After opening a camera, view the camera firmware, LxCameraViewer, and application algorithm versions in device information or the software version panel.
Upgrade camera firmware or an application algorithm
Open Basic tools → Function settings, select firmware or application-algorithm upgrade, and choose the delivered upgrade file as prompted.
Parameters and imaging
Import or export imaging parameters
Open Basic tools → Function settings to export the current camera configuration or load a saved configuration from a file.
Keep an application algorithm always on
Configure the operating mode in Application algorithm so the camera continues outputting the enabled algorithm results after the host application disconnects.
Get camera intrinsics
Open Basic tools → Function settings and read the camera intrinsic parameters.
Enable RGB-D alignment
Open Basic tools → 3D settings and enable RGB-D alignment.
